Architectural shingles run about $686 to $990 per square installed in Anaheim, which puts a typical 25-square roof at roughly $17,160 to $24,750. That is 32% above the California baseline. 2026 planning estimates, not quotes.
Roof replacement in Anaheim, California runs roughly 32% above the California state baseline in 2026, driven by local labor rates, permit fees, and code requirements. Title 24; tile/concrete common. Use this guide to size a per-square budget for asphalt shingles, standing-seam metal, or concrete/clay tile on a typical Anaheim home, then refine your estimate with our project estimator.
Anaheim runs about 32% above the California state baseline, so the state figures are scaled by 1.32 to give the local ranges below.
| Material | Per square installed | 20 squares | 25 squares | 30 squares |
|---|---|---|---|---|
| Architectural asphalt shingles | $686 – $990 | $13,728 – $19,800 | $17,160 – $24,750 | $20,592 – $29,700 |
| Standing-seam metal | $1,386 – $2,112 | $27,720 – $42,240 | $34,650 – $52,800 | $41,580 – $63,360 |
| Concrete or clay tile | $1,452 – $2,244 | $29,040 – $44,880 | $36,300 – $56,100 | $43,560 – $67,320 |
Figures are per square — 100 square feet of finished roof — for installed work including tear-off, and are 2026 planning estimates rather than quoted prices. Squares shown allow for a typical 6/12 pitch and 10% waste. Always get three written quotes before committing.
| Roof size | Squares | Asphalt shingle range |
|---|---|---|
| 1,200 sq ft footprint | 15 | $10,296 – $14,850 |
| 1,500 sq ft footprint | 18 | $12,355 – $17,820 |
| 2,000 sq ft footprint | 25 | $17,160 – $24,750 |
| 2,500 sq ft footprint | 31 | $21,278 – $30,690 |
| 3,000 sq ft footprint | 37 | $25,397 – $36,630 |
The California state permit average is around $450; large metros frequently sit above that and may add inspection or scaffolding requirements of their own.
A typical 25-square asphalt shingle roof in Anaheim works out at roughly $17,160 – $24,750 installed. That is the California baseline scaled by the local factor of 1.32.
Title 24; tile/concrete common. Metro labour rates, permit and inspection requirements, and disposal fees all differ from the state average, which is what the 1.32 multiplier represents.
In almost every jurisdiction yes, and a licensed contractor will pull it as part of the job. Replacing a roof without one can cause problems at resale and can give an insurer grounds to dispute a later claim.
Three, from licensed and insured local contractors, each written against the same scope. Ask specifically whether flashing, drip edge, underlayment, ridge vent and decking replacement are included, because that is where quotes usually differ.