Architectural shingles run about $420 to $580 per square installed in Milwaukee, which puts a typical 25-square roof at roughly $10,500 to $14,500. That is 0% above the Wisconsin baseline. 2026 planning estimates, not quotes.
Roof replacement in Milwaukee, Wisconsin runs roughly 0% above the Wisconsin state baseline in 2026, driven by local labor rates, permit fees, and code requirements. Heavy snow; 50 lb/sq ft minimum design load. Use this guide to size a per-square budget for asphalt shingles, standing-seam metal, or concrete/clay tile on a typical Milwaukee home, then refine your estimate with our project estimator.
Milwaukee runs about 0% above the Wisconsin state baseline, so the state figures are scaled by 1.00 to give the local ranges below.
| Material | Per square installed | 20 squares | 25 squares | 30 squares |
|---|---|---|---|---|
| Architectural asphalt shingles | $420 – $580 | $8,400 – $11,600 | $10,500 – $14,500 | $12,600 – $17,400 |
| Standing-seam metal | $900 – $1,400 | $18,000 – $28,000 | $22,500 – $35,000 | $27,000 – $42,000 |
| Concrete or clay tile | $1,000 – $1,550 | $20,000 – $31,000 | $25,000 – $38,750 | $30,000 – $46,500 |
Figures are per square — 100 square feet of finished roof — for installed work including tear-off, and are 2026 planning estimates rather than quoted prices. Squares shown allow for a typical 6/12 pitch and 10% waste. Always get three written quotes before committing.
| Roof size | Squares | Asphalt shingle range |
|---|---|---|
| 1,200 sq ft footprint | 15 | $6,300 – $8,700 |
| 1,500 sq ft footprint | 18 | $7,560 – $10,440 |
| 2,000 sq ft footprint | 25 | $10,500 – $14,500 |
| 2,500 sq ft footprint | 31 | $13,020 – $17,980 |
| 3,000 sq ft footprint | 37 | $15,540 – $21,460 |
The Wisconsin state permit average is around $230; large metros frequently sit above that and may add inspection or scaffolding requirements of their own.
A typical 25-square asphalt shingle roof in Milwaukee works out at roughly $10,500 – $14,500 installed. That is the Wisconsin baseline scaled by the local factor of 1.00.
Heavy snow; 50 lb/sq ft minimum design load. Metro labour rates, permit and inspection requirements, and disposal fees all differ from the state average, which is what the 1.00 multiplier represents.
In almost every jurisdiction yes, and a licensed contractor will pull it as part of the job. Replacing a roof without one can cause problems at resale and can give an insurer grounds to dispute a later claim.
Three, from licensed and insured local contractors, each written against the same scope. Ask specifically whether flashing, drip edge, underlayment, ridge vent and decking replacement are included, because that is where quotes usually differ.